Introduction

Hardware

About this document

This manual contains information about the connection to the local web interface (WebConfig) of Compleo eBOX smart, Compleo eBOX professional and Compleo eBOX touch. The purpose of this document is to describe how to properly configure and operate the advanced features of the WebConfig platform. This includes the implementation of important settings for optimal operation.

Please note

Make sure that the eBOX is set up and wired correctly. You will find a detailed assembly description in the user manual you received with your eBOX.

Preparations

To connect to the WebConfig of the eBOX, you need a working laptop and a LAN cable. Make sure you have the PUK of the eBOX ready to access the web interface. You can find the PUK on the last page of the user manual you received with your eBOX

System overview and structure

Before mounting the eBOX, make sure that the eCLICK is not connected to power. To access the eBOX web interface, the eBOX must be properly connected to the computer. For this to succeed, the entire system must be set up and wired as shown in Figure 1.

Take the eBOX and identify the connection points (colored red) on its back. Connect the black ribbon data cable of the eBOX to the port "5 Expansion Terminal".

All communication cables (e.g. LAN cable, etc) are connected to the interface board (See Figure 2).

Before plugging the eBOX into the eCLICK, several components must be connected with various cables. First the LAN cable of the eBOX (black LAN cable, see Fehler! Verweisquelle konnte nicht gefunden werden.) is connected to the LAN RJ50 Terminal (5) of the eCLICK. Then connect the eSMARTMETER (3a) to the port (3b) of the eCLICK. Then connect the white LAN cable of the eBOX to the LAN port 1 of the eCLICK. Please note: Port 2a is for the LAN cable (yellow cable, Figure 4), which allows you to connect your computer to the eBOX.

After successful cabling (Figure 4), the eBOX can be plugged into the eCLICK.

To do this, follow the installation steps 1 to 3:

1.Place the eBOX evenly on the eCLICK and push the eBOX until it stops.

2 Hold the eBOX while pulling down the locking bar on the eCLICK. Now release the locking bar. As soon as the locking bar is pulled up, press the eBOX by pressing the eCLICK.

3 If necessary, press the locking bar until it is in its original position again. Markings for orientation are visible on the eCLICK locking bar. Check whether the locking bar is fully inserted. The triangular recesses on the left and right of the locking bar must be flush with the eCLICK housing.

Now the voltage can be switched on to the eCLICK. In the next step you can connect your computer to the eBOX via a LAN cable

Initial access

You will need at least a laptop and a LAN cable. If the backend connection is to be made via a SIM card, now is a good time to insert it. Then connect the laptop to one of the Ethernet ports on the board in the charging station using a network cable.

Login information for WebConfig:

User name: admin Password: To log in to WebConfig, you need the PUK of your eBOX. You can find it on the back of the supplied user manual. If you have lost your PUK, please contact support. The default username is "admin".